Roller & Steam 2/3 days prior to styling
Step 1: Part the wig from the left hand side to right creating a deep side parting, then part the sides from the back sectioning from about were the back of the ear would sit.
Step 2: Using the plastic rollers begin on the sides rolling away from the head under towards the head, repeat this as shown in the direction of the diagram. Pin into place. At the back roller down wards using brick word rolling to make sure the sections don't sit to leave gaps.
Step 3: Steam the overall style thoroughly and leave in a warm place to dry.
Sections & Preparation
Step 1: Section around the front of the head about 2 inches in from about middle of the ear and pin this out of the way. (This will then be curled as shown in the chart above mirroring the rolling done onto the wig/ this should be done before makeup to leave time for the hair to cool and set)
Step 2: With the rest of the back section french plait tightly around into the centre of the back of the head and pin into place making sure that all parts of the hair are securely into place, apply wig cap and pin this onto the head using the plait as an anchor point pinning horizontally into the cap.
Hair Style
Wig: (Previous to on model's head)
Step 1: Taking out the rollers brush the hair and manipulate into the finger wave style by pushing up and brushing into the directions- when the style is complete apply sections clips to clip into place while styling & doing makeup.
Step 2: Apply wig onto the models head behind the models hair line and pin in using bun pins and create anchor point pining horizontaly across the head. Taking the hair lace pin this into place using bobbie pins, manipulating this to mirror the finger wave.
Models Hair:
Step 1: Taking out the curls previously set, brush these through when the wig is applied onto the head brush this into the wig hair and create a seamless finger wave style.
Step 2: Hair spray to finish.
No comments:
Post a Comment